Click image to view full size image
1. Product description:
The product is a kind of polymer modified asphalt materials, using polyester carpet or glass mat for the matrix, the surface covered with polyethylene film, aluminum foil or fine sand, the base covered with a release sheet,keep the self-adhesive flexible waterproof. The product has a good self-adhesive and bending properties.
2. Application:
Construction is simple, clean, and can be widely used in roofing, basement, bathroom, etc. waterproofing works, and for legislation to pave and stick and pipe wall (except heat pipes), bridges , and other complex environment, especially in open flame is prohibited, covert fire waterproofing works.
Cut flashing to the required length, remove the release film and press down the adhesive bitumen to the previously prepared surface.
Ensure full contact by smoothing down with a cloth, taking care to eliminate air bubbles.
Final rolling down of the edges with a wallpaper roller will ensure a good edge seal.
All overlaps should be a minimum of 25mm and well rolled down.
Note: In cold weather adhesion will be imporved by storing the roll in a warm room for 12 hours or more before use, or by gently warming the strip during application.Do not apply below 5 ℃.
Construction building material waterproof self adhesive flashing tape supplier
E-mail: